| Requirements | Standard atmospheric condition | Ambient temperature: 15 to 35
Relative humidity: 63% to 67%
Air pressure: 86 kpa to 106 kpa | Unless otherwise specified |
| Temperature | Operating: -25 to 85
Storage: -40 to 85 | |
| Ratings | Voltage: 125 Volts
Current: 1.5 Amperes | |
| Dimension | Refer to applicable product drawing | |
| Performance and Test Description | Appearance | Product shall meet requirements of applicable product drawing and specification. | Visual, dimensional and functional per applicable quality inspection plan. |
| Electrical | Low Level Contact Resistance | Terminal Pin1-Pin8: 40 milliohms maximum initial, 40 milliohms maximum after test
Switch: 100 milliohms maximum initial, 100 milliohms maximum after test | Mate subject connector with compatible connector. Then measure and record the contact resistance of the specimen under test with a test current of 100 mill-amperes maximum and 20 mill-volts open circuit voltage maximum. |
| Insulation Resistance | 500 Mega ohms minimum initial
200 Mega ohms minimum final | After 500 VDC for 1 minute, measure the insulation resistance between the adjacent contacts of mated and unmated connector assemblies. |
| Dielectric Withstanding Voltage | 1 minute hold with no breakdown or flashover.
Voltage: 500 VDC
Current leakage: 10.0 mA max. | Test between adjacent contacts of unmated connector assemblies. |
| Mechanical | Mating force | 25N Max. | Measure force necessary to mate the connector assemblies at a max of 12.5 mm/minute. |
| Durability | 750 cycles. Shall meet visual requirements, show no physical damage. | Mate and unmated connector assemblies for 750 cycles at a maximum rate of 20 cycles/min. |
| Environmental | Heat test | The insulation resistance must coincide previously specification. Shall meet visual requirements, show no physical damage. | Subject mated connectors to 85 2 for 96 hours. It shall be subjected to standard atmospheric condition for 1 hour after which measurements shall be made. |
| Steady State Humidity | The insulation resistance must coincide previously specification. Shall meet visual requirements, show no physical damage. | Subject mated connectors to relative humidity of 90% to 95%RH and a temperature of 40 2 for 96 hours. It shall be subjected to standard atmospheric condition for 1 hour after which measurements shall be made. |
| Salt Spray | Shall meet visual requirements, show no physical damage. | Subject mated connectors to 51% salt-solution concentration, 35+1/-2 for 8 hours. |
| Mounting characteristics | Solderability | Solderable area shall have minimum of 95% solder coverage. | Dip the pin in flux of R type for 5-10 seconds. Immerse the solder pin of the connector in the solder bath at 2455 for 4.0-5.0 seconds. |
| Mounting characteristics | Resistance to soldering heat | The contact resistance must coincide previously specification. Shall meet visual requirements, show no physical damage. | Reflow Soldering Conditions: Preheat: 180, 20.3 minutes. Soldering heat: Peak temperature 2605 within 10 seconds.
Soldering iron method: Bit temperature 35010, application time 1~5 sec. |
